12
Note:
1 [x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged according to the model of
the matrix switcher If the symbols exceed the effective range, it would be taken as a wrong command
2 In above commands, “[”and “]” are symbols for easy reading and do not need to be typed in actual
operation
3 Please remember to end the commands with the ending symbols “ ” and “;”
Detail Examples:
1. Transfer signals from an input channel to all output channels: [x1] All.
Example: To transfer signals from the input channel No 3 to all output channels Run Command:
“3All ”
2. Transfer all input signals to the corresponding output channels respectively: All#.
Example: If this command is carried out on an MVG1616-A matrix switcher, the status of it will be:
1->1, 2->2, 3->3, 4->4…16->16
3. Switch off all the output channels: All$.
Example: After running this command, there will be no signals on all the output channels
4. Check the version of the firmware: /^Version;
To check the version of the firmware
5. Switch off the detail feedback command from the COM port: /:MessageOff;
Switch off the detail feedback information from the COM port But, it will leave the “switch OK” as the
feedback, when you switch the matrix
6. Switch on the detail feedback command from the COM port: /:MessageOn;
Switch on the detail feedback information from the COM port it will show the detail switch informa-
tion when it switch Example: when switch 1->2 for Audio, it will feedback “A0102”
7. Transfer signals from an input channel to the corresponding output channel: [x]#.
Example: To transfer signals from the input channel No 5 to the output channel No 5 Run Command:
“5# ”
8. Switch off an output channel: [x]$.
Example: To switch off the output channel No 5 Run Command: “5$ ”
9. Switch video signals command: [x1] V[x2].
Example: To transfer the video signals from the input channel No 3 to the output channel No 5
Run Command: “3V5 ”
10. Switch audio signals command: [x1] A[x2].
Example: To Transfer the audio signals from the input channel No 10 to the output channel
Run Command: “10A2 ”
11. Switch both video and audio signals synchronously: [x1] B[x2].
Example: To transfer both the video and the audio signals from the input channel No 120 to the output
channel No 12,13,15 Run Command: “120B12,13,15 ”
12. Inquire the input channel to the output channel [x]: Status[x].
Example: To inquire the input channel to the output channel No 23 Run Command: “Status23 ”
13. Inquire the input channel to the output channels one by one: Status.
Example: To inquire the input channel to the output channels one by one Run Command: “Status ”
14. Save the present operation to the preset command [Y]: Save[Y].
Example: To save the present operation to the preset command No 7 Run Command: “Save7 ”
15. Recall the preset command [Y]: Recall[Y].
Example: To recall the preset command No 5 Run Command: “Recall5 ”
16. Clear the preset command [Y]: Clear[Y].
Example: To clear the preset command No 5 Run Command: “Clear5 ”
