AUTOplus manual
Page 40
APPENDICES
A. MAIN DISPLAY PARAMETERS
The parameters and their meanings are detailed as follows: -
FUEL:
The selected fuel will be displayed, i.e. PETROL.
•
PETROL – Leaded or Unleaded petrol/gasoline.
•
LPG – Liquid Petroleum Gas
•
CNG – Compressed Natural Gas
•
DIESEL
DATE :
Analyzer date. See
Set-Up menu
to change.
TIME :
Analyzer time. Use
Set-Up menu
to change.
BATTERY :
Displays the battery level from 0-100%. During normal data
display operation the analyzer will show
LOW BATTERY
briefly at
intervals of about 45 seconds for less than 30% of charge. The
analyzer will turn off if less than 10% charge is detected. With the
charger connected the display will read close to 100%.
Note: Allowing the battery to discharge fully may destroy it.
O2 :
Oxygen measured in the exhaust gas indicated in percentage %.
With the pump off the analyzer will display - - - -. If there is a fault
with the oxygen sensor then
FLT
will be displayed.
CO :
Carbon monoxide measured in the exhaust gas indicated in
percentage %. With the pump off the analyzer will display - - - -. If
there is a fault with the CO reading then
FLT
will be displayed.
CO2 :
Carbon dioxide measured in the exhaust gas in percentage %.
With the pump off the analyzer will display - - - -. If there is a fault
with the CO
2
reading then
FLT
will be displayed.
HC :
Hydrocarbons measured in the exhaust gas indicated in ppm
(parts per million) n-hexane (petrol). With the pump off the
analyzer will display - - - -. If there is a fault with the HC reading
then
FLT
will be displayed.
