Kane 255, Manual, Page: 22 / 36

Page 22
12. ANALYSER PROBLEM SOLVING
If any problems are not solved with these solutions, contact us or an
authorised repair center.
Fault symptom Causes / Solutions
 Oxygen too high

CO
2
too low
 Air leaking into probe, tubing, water
trap, connectors or internal to analyser.
 CO reading (- - - -)  Analyser was stored in a cold
environment and is not at normal
working temperature.

CO sensor needs replacing.

Pump is switched off

Batteries not holding
charge

Analyser not running on
mains adapter.

Batteries exhausted.

AC charger not giving correct output.

Fuse blown in charger plug.

Analyser does not
respond to flue gas

Particle filter blocked.

Probe or tubing blocked.

Pump not working or damaged with
contaminants.
 Net temperature or
Efficiency calculation
incorrect.
 Ambient temperature set wrong during
Automatic Calibration.

Flue temperature
readings erratic

Temperature plug reversed in socket.

Faulty connection or break in cable or
plug.

T flue or T nett displays
-(-OC-)

Probe not connected.

X-Air, EFF display (-O>-)

CO
2
reading is below 2%.

Analyser just continually
beeps

Turn dial back to MENU and press
ENTER