KANE905 Operators Manual
Page 22
level in the flue and hence dilute any toxic gas reading.
Oxygen referencing gives readings as if they were undiluted.
SMOKE:
Allows the user to enter a smoke test number from 0-9. This
value will be printed on the standard printout. Default value is
OFF.
RESET :
Allows the
user set the Oxygen to 20.9% and zero the toxic
sensors without turning the analyser off.
Selecting YES and
will
display the following screen.
RESET SENSORS
O2 % : 20.9
CO & NO = 0
PRESS ENTER
MENU TO ESCAPE
After pressing
the analyser will count down for 10
seconds and then return to the main display.
WARNING:
The sensors must only be reset if you are sure
they have been sampling fresh air for at least 3 minutes.
Errors in measurement will occur if the sensors are reset
during or just after sampling.
PITOT:
When pressure units set to m/s Pitot Mode is active, adjust
the PITOT setting/value here.
SUB MENU -
2. UNITS
T
EMP : C
GAS
: ppm
PRESS.
: mbar
EFF.
: GROSS
Allows all displayed units to be changed.
TEMP:
Choose from Centigrade,
C, or Fahrenheit,
F.
GAS:
Changes the toxic gas measurement units. Select from
volumetric readings, parts per million (ppm) or mass flow
reading milligrams per cubic meter (mg/m
3
). When set to
m/s. Pitot flow mode is active. FLOW will show on measure
screen instead of XAIR.
