K&S BASIC KS 1200i Owner'S Manual Download Page 3

“ON” MODE

“ON” MODE
When the ECON switch is in the “ON” position, the control unit monitors the engine speed, reducing it commensurate 

with the connected load. If the engine speed is not enough to generate electricity to provide the load, the control unit 

will automatically increase the engine speed. 
As a result, fuel consumption is optimized and noise levels are reduced.

“OFF” MODE

“OFF” MODE

The ECON switch must be set back to “OFF” when using electrical devices requiring a high starting current, such as a 

compressor or submersible pump.

The ECON switch must be set to “OFF” to increase engine speed 

to nominal. When connecting multiple power consumers to the 

generator,  be  sure  to  first  connect  the  one  with  the  highest 

starting current, and the device with the lowest starting current 

should be connected last.

IMPORTANT!

The ECON switch must be set back to “OFF” when using electrical 

devices requiring a high starting current, such as a compressor or 

submersible pump.

IMPORTANT!

General view of inverter generators, description of control panels, s

General view of inverter generators, description of control panels, safety symbols and description of inscriptions 

afety symbols and description of inscriptions 

can be found in the full electronic version.

can be found in the full electronic version.

PRECAUTIONS WHEN WORKING WITH

GASOLINE GENERATOR

1.2

Do not start the generator operation upon presence of electric load! Disconnect the load before you stop the engine. 

Only unleaded gasoline is recommended for the generator.

 It is forbidden to use kerosene or other 

fuel types. Before running the generator, it is necessary to define the place and means of its emergency stop. Do not 

refuel the running generator.

Fuel contaminates the land and groundwater. Do not allow the 

leaking gasoline from the tank!

ATTENTION – DANGER!

ECON FUNCTION

ECON FUNCTION
1. Start the engine.

2. Set the ECON switch to “ON”.

3. Plug the device into an AC outlet.

4. Make sure the AC indicator light is on.

5. Turn on the electrical device.

FUNCTIONAL DESCRIPTION 

OF INVERTER GENERATORS

2

www.ks-power.de/en

   

|

    2

Summary of Contents for KS 1200i













Reviews: