Technical data
Material
Floor protector, bracket, base brace, clamping piece: Plastic, black.
Knurled washer: black anodised.
Threaded bolt, clamping bolt, ball joint, rivet, pan head screw:
Steel, galvanised.
Base tube, extension tube, end tube, legs: steel, powder coated black.
Joint: zinc die-cast, powder-coated black.
Threaded pin: steel, bright.
Clamping screw: Plastic and steel, galvanised.
Load capacity
1 kg
Dimensions and
adjustment range
Foot circle: ø 680 mm
Height: 555 mm up to 1355 mm
Ball joint 360° rotatable and 90° tiltable
Packing
61 x 94 x 581 mm
Weight
1.1 kg
Assembly
1.) Unpack and check item for damage and completeness
The camera stand is fully assembled .
To set up the stand, loosen the clamping screw on the base and move
the three legs outward, reattach the clamping screw. Good stability can
be reached when the foot circle diameter is set as large as possible.
The largest foot circle diameter is reached when the base braces are
horizontal.
Screw the equipment onto the stand. If necessary, the equipment can
be locked in place with the help of the knurled disc.
To adjust the direction or the angular position, hold the screwed-on
equipment and loosen the clamping screw. Set the desired position on
the ball joint and retighten clamp. The height can be adjusted through
the two knurled screws.
Dismantling is carried out in reverse order
2.) Mounting the equipment and adjusting the desired position.
!When setting the position, there is a crushing risk between the components!
