Tightly
press the 2 clamp parts towards each other while snapping the Velcro together.
If done properly the non-slip-padding will now hold the clamp and mic securely to the instrument.
If necessary you can further tighten the clamp by following the instructions below.
For a start, position the mic as shown. Aim it more towards the soundhole for a bassier tone or
more towards the 14
th
fret for a tighter and brighter sound.
Removal and Re-Installation:
Remove the mic by pulling the assembled clamp/mic off the guitar.
Or, in case you want to leave the clamp on the instrument, carefully
remove the mic from the little clip on the clamp.
If you need to tighten the clamp
, loosen the bottom clamp part to one
side but leave it attached at the edge by the Velcro (see the photo to the
right). Move it up by 1/16” and press the Velcro back together.
If you re-install the clamp to the same guitar, slide the assembled
clamp/mic onto the guitar.
If you attach it to a different guitar, please follow the “first-time-
installation-instructions” above.
