Aetos Installation Manual
11.2
Flap Settings
Scale start
defines the starting value (low limit) of the scale.
Color until
defines the color (red, green, yellow) used from previous limit
until the given value. Note that limiting value must be always larger
than the previous one.
Add
adds a new color band at the end.
The
Color until
items are added until full scale range is defined. A
Color
until
item can be also removed or inserted.
A valid parameter requires at least two
Color until
items. If only one is given,
Aetos will not draw the scale properly or will not draw it at all.
Observe the arc on the left side of the window. It displays current color bands.
The arc must be valid. If you see
Invalid
on the right, then the color bands
are not properly defined and parameter may not show on the screen even if it
is enabled.
11.2
Flap Settings
Before you can proceed with the flap settings, plaese make sure that flap
sensor was correctly connected to Daqu (see Daqu manual), Daqu channel was
correctly configured (see section 13.3) and
Min-Max
position was determined
(see section 13.3.2).
Flaps may have several fixed positions between fully retracted and fully ex-
tended. This window is used to define visual flap stops markings, which are
relative to the full flap travel. Typically, flap stop 0 corresponds to 0% of
travel and full flaps to 100%. Aetos allows setting up to five different posi-
tion. Figure 55 shows an example.
Time of travel
defines approximate time of flap from 0 to 100%. This value
is used with combination of flap position sensor to detect the flap move-
ment and also to prevent sporadic flap movement messages.
If flap movement window appears on the screen, but flaps are not mov-
ing, increase this value.
If flap movement window does not appear on the screen, or appears too
late and the flaps are moving, reduce this value.
Flap stop
define flap position in percentage of full travel range.
Flap stops that are not used, must be set to zero.
58
©
Kanardia
2019–2020