User manual
wM-Bus Dongle SW Tool
Appendix C:
Flonidan Rev. B meter set-up
5512-1
057
GB /
12.2011 /
A1
Figure 10
If the option board (radio module) in the meter is an old Flonidan Revision B type, the set-up should
be as follows:
•
Transfer the data from the
Main
tab, or enter the
METER ADDRESS
manually.
•
Set the options as shown, i.e. tick the checkboxes
Meter enabled
,
2-way radio
,
Rev B
compatible
and
Meter data valid
(
Options in hex
= 23).
•
If the meter is not installed, set the
Meter Install state
to 255. Next time the meter sends out an
ACCESS DEMAND INSTALL STATE (Ci=0x06)
, the Dongle will acknowledge this, and the state will
change to 1 when seeing the next message from the meter.
•
Set
Meter M-Bus address
to where you want the meter to respond on the M-Bus.
•
T1 period
and
T2 fraction
cannot be set.
•
IEK
and
KEY
are not used.
•
Set the
Rev B barcode
. As this is not included in the radio message, the Dongle will add this to
the wired M-BUS REQ_UD2 response.
•
The
Option Board
data fields are not used.
13
