Kampmann PowerKon nano, Assembly, Installation And Operating Instructions

Page: 27 / 44

PowerKon nano
PowerKon nano
Assembly, installation and operating instructions
27
7.3 Electromechanical connection, 230 V (*00)
Wiring (*00)
All factory-fitted actuators are wired to terminals on the electromechanical model (*00).
The operating voltage must be provided by a voltage supply (230 V AC) by others.
The valves can be actuated by 24 V DC or 230 V AC.
The speed of the EC fans used can be continuously variably controlled by a 0-10 V DC signal. In the event of a motor
fault, the intelligent motor electronics switches off the fan automatically.
Note these points in the following wiring diagrams for PowerKon nano with electromechanical control:
Comply with the details on cable types and cabling with due consideration for VDE 0100.
Without *: NYM-J. The requisite number of wires, including protective earth, is stated on the cable. Cross-sections are
not stated, as the cable length is involved in the calculation of the cross-section.
With *: J-Y(ST)Y 0.8mm. Lay separately from power lines.
If other types of cables are used, they must be at least equivalent.
The terminals on the unit are suitable for a maximum wire cross-section of 2.5 mm².
The
electrical data [
}
22] need to be respected when rating the in situ mains power supply and fusing.