Kampmann Katherm QK 190, Assembly, Installation And Operating Instructions

Page: 25 / 52

Katherm QK
Assembly, installation and operating instructions
25
Katherm QK, KaControl version (*C1)
Trench
length [mm] Nominal
voltage [V
DC] Mains fre-
quency [Hz] Nominal
power [W] Nominal
current [A] Leakage cur-
rent [mA] Ri analogue
input [kΩ] IP class Protection
class
1000 230 50 7 0.08 - 20 IP00 I
1200 230 50 8.4 0.09 - 20 IP00 I
1400 230 50 9.9 0.10 - 20 IP00 I
1600 230 50 11.3 0.11 - 20 IP00 I
1800 230 50 12.7 0.12 - 20 IP00 I
2000 230 50 12.7 0.12 - 20 IP00 I
2200 230 50 14.1 0.13 - 20 IP00 I
2400 230 50 15.5 0.14 - 20 IP00 I
2600 230 50 17 0.15 - 20 IP00 I
2800 230 50 18.4 0.15 - 20 IP00 I
3000 230 50 19.8 0.16 - 20 IP00 I
3200 230 50 21.2 0.17 - 20 IP00 I
Tab. 7: Maximum electrical rating values Katherm QK
7.2 Electromechanical connection, 24 V (*24)
Note these points in the following wiring diagrams with electromechanical control:
Comply with the details on cable types and cabling with due consideration for VDE 0100.
Without *: NYM-J. The requisite number of wires, including protective earth, is stated on the cable. Cross-sections are
not stated, as the cable length is involved in the calculation of the cross-section.
With *: J-Y(ST)Y 0.8mm. Lay separately from power lines.
If other types of cables are used, they must be at least equivalent.
The terminals on the unit are suitable for a maximum wire cross-section of 2.5 mm².
The Electrical data for PowerKon nano, 230 V need to be respected when rating the in situ mains power supply and fus-
ing.