EN
8
4445103453
Setting up the tent
A
I
Keep the following tips in mind while setting up the tent:
•
The figures provide a general overview of the set-up. The actual set-up
will vary slightly based on the model of tent.
•
Get help. The set-up is easier with more people.
•
Thread the poles through the outer sleeves according to their color
code.
•
After standing the tent upright, check the corner pegs and re-peg if
necessary. The groundsheet on the inside should be taut and in a
rectangular shape.
•
Peg the guy lines so that the tent is under tension without distorting
the shape.
•
If available, attach the storm straps.
•
Check the guy lines from time to time to ensure adequate tension, if
necessary use the runners to adjust.
Set up the tent as follows:
1. To protect the tent from dirt and damage, lay down a groundsheet or
footprint before unpacking.
2. Unpack the tent.
3. Separate and identify the different components.
4. Proceed as shown to set up the tent (fig.
Dismantling the tent
A
1. Reverse the set up procedure.
2. Push the poles out of the sleeves, do not pull.
3. Ensure that all parts are clean before packing in the carry bag.
4. If the tent is wet or damp, dry fully as soon as possible.
Cleaning and maintenance
A
1. If necessary, clean the product with clean water and a soft brush.
2. Apply impregnation against water and UV radiation before each trip.
Storing the tent
I
1.
Clean the tent.
2. Air fully and ensure the tent is totally dry before packing away.
3. Store in a well ventilated dry place.
Troubleshooting
I
I
Condensation
All tents suffer from internal condensation if one or more of the following
conditions apply:
•
high air humidity
•
high ground moisture
•
a drop in temperature
Severe condensation can run down the inside of the roof and drip off ties,
tapes and other internal fittings and can be mistaken for leaking.
➤
Increase ventilation by opening doors and/or windows.
➤
Install a waterproof groundsheet.
Disposal
➤
Place the packaging material in the appropriate recycling waste bins,
wherever possible.
M
If you wish to finally dispose of the product, ask your local recy-
cling center or specialist dealer for details about how to do
this in accordance with the applicable disposal regulations.
Warranty
For repair and warranty processing, please include the following docu-
ments when you send in the device:
•
A copy of the receipt with purchase date
•
A reason for the claim or description of the fault
NOTICE! Material damage
Do not open or close the zippers by force.
NOTE
•
The tent comes with general purpose pegs. These will
be suitable for many sites but for some types of ground
special pegs will be needed. Ask your dealer.
•
Drive the pegs at a 45° angle away from the tent into the
ground.
•
Peg the guy lines in line with the seam it starts from.
NOTICE! Material damage
Do not use force when dismantling the tent. Otherwise you
might damage any material.
NOTICE! Material damage
•
Do not use sharp or hard objects or cleaning agents for
cleaning.
•
Do not use alcohol based materials, chemicals, soap
and detergents for cleaning.
•
Remove bird droppings and tree resin as soon as
possible to avoid permanent damage to the material.
NOTE
•
Fully set up the tent for cleaning.
•
Choose a sunny day for cleaning to ensure the material
will dry thoroughly.
NOTE
•
During first exposure to water there may be some
moisture at the seams. Through this moisture the threads
will swell and fill the holes that are created in the sewing
process.
•
A fully equipped spare parts kit should include:
–
waterproofer
–
repair tape and repair solution
–
silicone spray for the zippers
–
spare pegs
Problem
Solution
Water leak
➤
Check for leaky seams, damaged
tapings and moist areas.
➤
If you cannot find any leaks, see
chapter “Condensation” on page 8.
➤
If you find any leaks, apply seam
sealant.
Rip in the fabric
➤
Use repair tape to seal the fabric.
➤
Have repairs carried out by an
authorized specialist.
Shock cord connecting the poles
has broken
➤
Purchase a replacement shock cord.
➤
Replace the shock cord.
Pole has broken
➤
Use a metal peg as a splint by taping it
to the broken pole.
➤
Purchase a new pole.
Summary of Contents for Mersea 3
