PU0165-UM-01-17 Rev.A
4
Instructions
Thank you for purchasing the Kampa
®
Gale pump. For safety reasons and to
maximise the performance of this product, ensure that you read these instructions
before use. Please retain these instructions for future reference.
This pump is designed for inflatables such as awnings and tents and will
automatically cut-out when the preset pressure is achieved.
Important
This pump must only be used with a DC 12 Volt power supply.
To avoid the risk of electric shock, do not use in wet conditions or submerge in
any liquid. Store in a dry place.
Do not direct air stream at face or body.
Keep the inflation port free of any obstruction during use. Ensure the pump has
adequate ventilation during use.
Do not attempt to put any object/implement into the port at any time. This is
dangerous during use but can also damage the internal pump mechanisms.
Keep out of reach of children. Keep children and pets away from the pump
whilst in operation. Do not allow the pump to be operated by persons
unfamiliar with the product.
This pump uses a pressure induction system with a margin of error ±0.5 PSI.
Do not operate the pump continuously for longer than 15 minutes as the motor
may overheat and cause internal damage. Allow the pump to cool down for 30
minutes after 15 minutes of continuous use.
Do not leave the pump unattended whilst in operation. Pay attention in order to
ensure over-inflation does not occur that could cause damage to your inflatable
item.
Do not use with any accessory or attachments other than those originally
included or recommended by Kampa UK Limited.
Do not use this pump if any part is damaged in any way. This product has no
user serviceable parts. Do not attempt any repair.
Please check that the 12 Volt power source socket is functioning correctly, is not
damaged and has no rust, residue or foreign matter inside.
Operation - Inflation
1.
Start the vehicle (or switch on power source). Insert the DC plug (G) into the
12V socket.
2.
Connect the Air Hose (I) to the Inflation Port (A). Rotate the blue collar to
screw the air hose onto the threaded inflation port until secure (do not
overtighten).
