10
Using Your Kambrook Heater
Before First Use
Remove your heater from its carton
and associated protective wrapping.
Unwind the cord to its full length and
remove any protective cardboard
or foam that may have been used
to minimise transportation damage.
Place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and
outlets to ensure no foreign material is
blocking these areas.
Turning Your Heater On
Before turning the heater ON, turn
the variable thermostat control (for
KFH610 & KFH660 models only) to the
minimum position, then turn the heat
settings control to the ‘OFF’ position.
Plug the cord into a 230V or 240V
electrical outlet and switch on. Be
sure the plug fits tightly as a loose fit
will cause overheating and damage
the plug.
WARNING:
To avoid an
electrical circuit overload,
it is recommended that
no other appliances are
plugged into the same
circuit with your heater
when you switch the
unit on.
Turn the variable thermostat control to
the maximum position, and then turn
the heat setting control to the desired
heat setting.
The fan heater has four modes;
OFF - Shuts off the heater and fan
FAN - For fan only operation
1 - Low heat setting (1200 watts)
2 - High heat setting (2400 watts)
Turning the heat settings control to
setting ‘1’ will set the heater into low
heat mode (1200 watts).
Turning the heat settings control to
setting ‘2’ will set the heater to high
heat mode (2400 watts).
Turning the heat settings control to fan
mode
is for fan-only operation with
no output of heat.
To turn the heater OFF, turn the heat
setting control to the ‘OFF’ position,
and turn the variable thermostat
control (for KFH610 & KFH660 models
only) to 'MIN' position. Turn off at the
power outlet and remove the plug
from the power outlet.
WARNING:
This heater
features a tip-over switch.
If the heater tips over, it
will automatically switch
off. Once placed back in
the upright position the
heater will automatically
switch on again.
Setting the Variable
Thermostat Control
(For KFH610 & KFH660
models only)
The variable thermostat control can
be used to maintain your desired
room temperature.
1. To set the desired temperature,
turn the heat setting control to
setting ‘2’ and turn the variable
thermostat control to the ‘MAX’
position to set the heater into
high heat mode.
