Kambrook Steamline KIR795, Instruction Booklet

Page: 6 / 18

5
• Always set the temperature control
dial to MIN, switch the iron off and
remove the plug from the power
outlet when filling the water tank.
Do not touch the hot surface of the
soleplate or the skirt area above the
soleplate at any time; especially when
the water tank is not attached.
• Only push the self-clean lever when
you want to activate the self-cleaning
function. Do not push this lever whilst
ironing. Boiling water and steam will
drip from the holes on the soleplate
during the cleaning process. Due
caution and attention should be
exercised.
• If the iron is set to a low temperature
on the temperature control (i.e.
synthetic or silk) and also on any of
the steam control settings, there may
be leakage from the soleplate. This is
due to the iron temperature not being
high enough to vaporize the water
and create steam. Therefore, ensure
that the steam control is always set
to correspond with the setting on the
temperature control as seen in Table
A under ‘Setting the Temperature’ on
page 10.
• Always turn the variable temperature
control dial to minimum, switch off at
the power outlet and then unplug the
iron when not in use.
• When placing the iron on its heel,
ensure that the surface on which the
heel is placed is stable.
• If the iron is not used for an extended
period, disconnect the iron from the
power outlet.
• Do not use the iron if it has been
dropped, if there are visible signs of
damage or if it is leaking.
• Always switch the iron off and then
unplug from the power outlet:
- Before filling or emptying the water
tank.
- Before leaving the iron unattended.
- Before cleaning and maintenance,
unless otherwise specified in this
booklet.
- Immediately after use.
• The iron incorporates a thermal safety
fuse to protect it from overheating.
However, the iron should not be left
unattended while it is connected to
the power outlet. Special care should
always be taken when there are
children in the home/ vicinity of the
iron.
• Allow the iron to cool completely
before storing in an upright position on
its heel.
• Do not leave the iron unattended while
in use, connected or on an ironing
board.
• Store the iron out of reach of children.
• Do not allow the iron to lay flat on the
soleplate when stored as residual water
may seep through the steam holes, if
the tank is not empty.
• Always store the iron in the upright
position on its heel.
• Do not store the iron with water in the
water tank. Always empty the tank
after use.
• Ensure the iron is cool before storing or
wrapping the cord around the storage
heel facility.
• To prevent damage to the iron do not
use alkaline cleaning agents when
cleaning, uses a soft cloth and mild
detergent.
• Regularly inspect the supply cord, plug
and actual appliance for any damage.
If damage is found in any way, or the
iron has been dropped, immediately
cease use of the appliance and return
the entire appliance to your nearest
authorized Kambrook Service Centre
for examination, replacement or repair.