Kambrook Pulp Select KCP110, Instruction Booklet

Page: 8 / 12

8
Juicing
1.
Stand the citrus press on a dry,
even surface that is easy to clean.
Fully unwind the power cord from
the wrap around cord storage on
the motor base.
2. Connect the power plug to a 230V
or 240V power outlet and turn the
power on.
3.
Remove the storage lid.
4.
Fit the appropriate citrus juicing
cone onto the drive shaft to suit
the citrus that is being juiced (see
suggested juicing cone size table
on page 9).
NOTE:
Only the small juicing
cone fits onto the drive shaft. The
large juicing cone can only be
used when attached to the small
juicing cone.
5.
Using the two strainers locked
together allows the slide selector
to adjust the level of pulp and
seeds that fall into the juicing jug.
Slide the pulp selector between
the five settings to preference.
6. Select your choice of citrus fruit,
wash and cut in half.
7.
Press the halved fruit down onto
the top of the juicing cone to
activate the citrus press. The
juicing cone will start to turn and
juice will begin to flow into the
juice jug. Lifting the citrus fruit off of
the juicing cone will stop rotation.
To restart, press the fruit down on
the cone.
Operating Instructions
continued
8.
Stopping and starting downward
pressure on the cone may cause
the citrus press to change its
rotational direction. This is normal
and assists with maximum juicing.
9.
Continue juicing until the fruit
half is well-juiced or for about 5-7
seconds. Juice citrus halves until
the quantity desired is reached,
not exceeding the 1.0 litre of juice
maximum level of the juice jug.
During juicing, monitor the level
of pulp and seeds in the strainer
and empty if required (see NOTE
below).
WARNING:
Do not
operate the citrus press
for more than 8 seconds
continuously at one time.
Allow the motor to cool
between use.
NOTE:
The strainer should be
emptied when full of pulp and
seeds. The strainer can be
emptied during juicing by turning
the juicer off at the power outlet
and carefully removing the juicing
cone(s) and strainers. Clean and
replace the strainers and juicing
cone(s) before continuing use.
Do not allow the strainers to
overfill as this may prevent correct
operation or damage the unit.