11
10
Fan Head assembly
1.
Remove the blade cap from
the motor shaft by turning it
clockwise and then remove the
rear grille locking nut by turning it
counter-clockwise.
NOTE:
You may have to hold the
shaft in place with one hand to
unscrew the blade cap with the
other hand (See Fig 6).
Fig. 6
2.
Place the rear grille centre
hole on the front of the motor
housing, lining up with the
locating pins and ensuring that
the tear drop shaped lug
is
pointing towards the ground
(See Fig 7).
Fig. 7
3.
Refit the rear grille locking nut
and turn in a clockwise direction
to fix the rear grille into place.
Make sure that the rear grille has
not slipped off the locating pins
before tightening. This should be
done by hand. Do not force
(See Fig 8).
Fig. 8
4.
Insert the notches on the back part
of the fan blade onto the motor
shaft pins (See Fig 9a and b).
Fig. 9a
Fig. 9b
5.
Refit the blade cap onto the
motor shaft and tighten in a
counter-clockwise direction to
fix the blade in place. This should
be done by hand. Do not force
(See Fig 10).
Fig. 10
6.
Remove the small screw from the
clear plastic clasp located at
the bottom part of the front grille
and set safely aside (See Fig 11).
Fig. 11
7.
Place the front grille over the
rear grille so that the tabs at the
top of the front grille fit over the
rear grille rim (See Fig 12).
Fig. 12
Using Your Kambrook Pedestal Fan
Continued...
Correct
Incorrect