background image

5

Important Safeguards For All  

Electrical Appliances  

•   Carefully read all instructions before operating 

the appliance and save for future reference.

•   Remove and safely discard all packaging 

material and promotional labels before using 

the appliance for the first time.

•   Fully unwind the power cord before use.
•   Do not let the power cord hang over the edge 

of a bench or table, touch hot surfaces or 

become knotted.

•   To protect against electric shock, do not 

immerse the power cord, power plug or 

appliance in water or any other liquid, unless it 

is recommended in the cleaning instructions.

•   The appliance is not intended for use by 

persons (including children) with reduced 

physical, sensory or mental capabilities, or lack 

of experience and knowledge, unless they 

have been given supervision or instruction 

concerning use of the appliance, by a person 

responsible for their safety.

•   Children should be supervised to ensure that 

they do not play with the appliance.

•   It is recommended to inspect the appliance 

regularly. Do not use the appliance if the 

power supply cord, plug, connector or 

appliance becomes damaged in anyway.  

Return the entire appliance to the nearest 

authorised Kambrook Service Centre for 

examination and/or repair.

•   Any maintenance other than cleaning should 

be performed at an authorised Kambrook 

Service Centre.

•   This appliance is for household use only. Do not 

use this appliance for other than its intended 

use. Do not use in moving vehicles or boats.  

Do not use outdoors. 

Misuse may cause injury.

•   The installation of a residual current device 

(safety switch) is recommended to provide 

additional safety protection when using 

electrical appliances. It is advisable that a 

safety switch with a rated residual operating 

current not exceeding 30mA be installed in 

the electrical circuit supplying the appliance. 

See your electrician for professional advice

•   Always turn the appliance to the OFF 

position, switch off at the power outlet 

and unplug at the power outlet when the 

appliance is not in use.

•   Before cleaning, always turn the appliance to 

the OFF position, switch off at the power outlet, 

unplug at the power outlet and remove the 

power cord, if detachable, from the appliance 

and allow all parts to cool.

•   Do not place this appliance on or near a heat 

source, such as hot plate, oven or heaters. 

•   Position the appliance at a minimum 

distance of 20cm away from walls, curtains 

and other heat or steam sensitive materials 

and provide adequate space above and on 

all sides for air circulation. 

•  Do not allow materials that have been in 

contact with oil, petroleum based products 

or drying fluids to come in contact with the 

heater.

•  Do not run the cord under carpeting or cover 

the cord with rugs, runners or the like. Arrange 

the cord away from traffic areas and where it 

will not be tripped over.

•  To disconnect the heater, switch control to off, 

turn off at the power outlet then remove the 

plug from the outlet.

•  Do not insert or allow foreign objects to pass 

through the inlet or outlet openings. This may 

cause an electric shock, fire or damage the 

heater.

•  Do not touch hot surfaces.
•  Switch off at the control switch and power 

outlet, then unplug and allow the heater to 

cool down before cleaning or storing.

•  Use this heater only as described in this 

instruction manual. Any other use not 

recommended by the manufacturer may 

cause fire electric shock or injury and voids all 

warranties.

•  Keep combustible materials such as drapes 

and other furnishings at least 2.0 metres from 

the front and 0.5m from the sides and rear 

(when it is intended for floor use) and 1.0m 

from the top of the heater. 

•  To prevent a possible fire or heat damage, 

allow ample space around the heater (at 

least 2.0m at front, 1.0m at the top and 0.5m at 

the rear and sides when it is intended for floor 

use), (at least 2.0m at the front, 1.0m at the top 

and 0.5m at the sides when it is wall mounted) 

and do not totally or partially block the air inlet 

or outlets in any manner. Check the openings 

from time to time for accumulated dust.

KMH100_IB_A11_FA.indd   5

14/09/11   1:58 PM

Summary of Contents for KMH100

















Reviews: