7
Operation And Assembly Of Your Kambrook
Essentials Power Mix
Assembly Of The Beaters
WARNING:
Ensure the
mixer is switched off
and unplugged from
the power outlet before
attaching the beaters to
the mixer.
Insert each beater shaft into the left
and right beater sockets underneath
the mixer body (see Fig. 1).
Fig. 1
Insert the beaters by pushing the
shaft of the socket, turning slightly if
required until they lock into place.
Removing The Beaters
Remove the beaters by pressing
the eject button while grasping the
beater shafts. The beaters will be
released automatically. DO NOT try
to pull the beaters out of the sockets.
Using Your Kambrook
Essentials Power Mix
Ensure that the speed selector
switch is set to the (O) position.
Select a mixing bowl large enough
to accommodate the beaters, as a
bowl that is too small will damage
the beaters.
Add ingredients to a mixing bowl as
per the recipe or your requirements.
Plug the cord into a 230V or 240V
power point and turn the power
point on.
Place the beaters into the ingredients
in the mixing bowl. To commence
mixing, move the speed selector switch
to the right to the required speed.
Always begin mixing on a lower
speed setting to prevent splattering,
increasing to the desired speed for
the mixing task.
The speed setting can be adjusted
during operation by moving the
switch from left to right.
Move the mixer in a slight circular
action during mixing to allow
the beaters to efficiently mix the
ingredients. Stop the mixer now and
then, using a plastic spatula, scrape
down the sides of the mixing bowl,
then continue mixing.
NOTE:
Always turn the Essentials
Power Mix off if you need to
scrape down the bowl during use.
NOTE:
Avoid allowing the
beaters to hit against the side of
the mixing bowl while the mixer
is operating as this will result in
damage to the beaters.
KHM10_IB_FA.indd 7
11/02/10 9:32 AM
