9
Using Your Kambrook Heater
Before First Use
Remove your heater from its carton
and associated protective wrapping.
Unwind the cord to its full length and
remove any protective cardboard
or foam that may have been used
to minimise transportation damage.
Place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and
outlets to ensure no foreign material is
blocking these areas. The heater must
always be operated with the rear air
filter in position.
Turning Your Heater On
Before turning the heater ON, turn
the thermostat control to the
minimum position, then turn the heat
settings control to the ‘OFF’ position.
Plug the cord into a 230V or 240V
electrical outlet. Be sure the plug
fits tightly as a loose fit will cause
overheating and damage the plug.
NOTE:
To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit with your heater
when you switch the unit on.
Turn the thermostat control to the
maximum position, and then turn
the heat settings control to desired
heat setting.
Turning the heat settings control to
setting ‘1’ will set the heater into
low heat mode (900 watts).
Turning the heat settings control to
setting ‘2’ will set the heater to
high heat mode (1800 watts).
Turning the heat settings control to fan
mode is for fan-only operation with
no output of heat.
To turn the heater OFF, turn the heat
settings control to ‘OFF’ position and
variable thermostat control to ‘MIN’
position. This will turn the neon power
indicator light off. Turn off at the power
outlet and remove the plug from the
power outlet.
NOTE:
There is a tip-over
switch fitted to this heater. If
the heater is tipped over, it
will automatically turn off. The
heater will need to be placed
back into the upright position
to resume heating again.
Setting the Variable
Thermostat Control
The variable temperature control
can be used to maintain your
desired temperature.
1.
To set the desired temperature,
turn the heat setting control to
setting ‘2’ and turn the thermostat
control to the ‘MAX’ position to set
the heater into high heat mode.
2.
Once the room temperature feels
comfortable, turn the thermostat
control slowly to the minimal
position until a click sound is
heard. This automatically allows
the thermostat control to remain
at the desired temperature.
3.
When the air temperature drops
below the set temperature the
unit will begin heating again.
