11
•
Ensure that the heater is switched
OFF, then switched off and
disconnected from the power
outlet before cleaning.
•
Use a clean, dry cloth to clean the
external surfaces of the heater. If
the heater has collected dust or
dirt inside the unit or around the
elements, have the unit cleaned by
a qualified service agent.
Do not
operate the heater in this condition.
•
Do not attempt to open the case
of the heater at any time as there
are no customer serviceable
parts inside.
•
When not in use, store the heater
(preferably in its original box) in a
cool, clean and dry location.
Cleaning the Filter
Your Kambrook Personal Ceramic
Heater comes with a mesh filter located
at the rear of the heater to help keep
dust and debris away from the working
parts. It is recommended to regularly
check your heaters filter for clogging
and dust build up. The filter should be
checked after every use to ensure
heating efficient performance.
Always switch the heater to OFF, then
switch off at the power outlet and
unplug from the power outlet prior to
removing the filter for cleaning.
To access the filter, ensure the heater is
in the upright position and then remove
the filter cover by pulling down on the
two release levers at the top of the
cover and then carefully lift the cover
upwards until it is completely free of the
heater (see Fig 1).
Care, Cleaning and Storage
Fig. 2
It is then necessary to separate the mesh
filter from the filter cover (see Fig 2).
Fig. 2
Once separated, shake both the filter
cover and the mesh filter into a rubbish
receptacle until all fine dust particles
and debris are removed. Wipe over
with a soft, dry cloth if required to
remove particles.
To replace, reinsert the mesh filter to the
filter cover, align the two tabs at the
back of the filter lid with the two holes at
the back of the lid, and then press down
on the cover until it “clicks”.
