11
NOTE:
Do not dry in a tumble
dryer, microwave, oven or near
a naked flame. The filter and
filter case must be completely
dry before replacing into
the vacuum. Failure to allow
the filter to completely dry
may result in damage to the
vacuum motor.
NOTE:
A second HEPA filter is
supplied for convenience,
ideal for when a used filter is
being cleaned.
Fig. 12
NOTE:
When replacing the dust
container HEPA filter, all three
components (HEPA filter, foam
filter and plastic casing) need
to be replaced.
4.
To place the filter back in the dust
container, ensure that the filter is
completely dry before use. Close
the bottom of the container.
5.
Simply place the foam filter into
the back of the HEPA filter and
then click the filter assembly into
the back of the dust container.
Fig. 13
6. To remove and clean the CaptivG3
cone from inside the dust container,
firstly ensure the dust container
has been emptied. Follow the
‘EMPTYING THE DUST CONTAINER’
instructions.
Fig. 14
Press the ‘PUSH’ button located
beneath the hose inlet
connection on the front of the
dust container. The bottom of the
container will release. Grip the
two pockets at the base of the
cone with two fingers, twist anti-
clockwise to ‘OPEN’ and pull to
remove the cone.
KBV250-220-280_IB_B11.indd 11
23/08/11 10:12 AM
