9
WARNING:
Do not use the
unit without a dust bag in
place.
Always switch the vacuum cleaner
‘OFF’, then switch off at the power
outlet and then unplug the appliance
prior to cleaning or replacing filters.
Cleaning and
Replacing Filters
Filters must be cleaned from time to
time to remove the fine dust particles
that have been collected. This can be
done by shaking them; however after
approximately 5 dust bag changes,
the filters should be replaced.
Motor Protection Filter
The motor protection filter must
always be in place when operating
the vacuum otherwise damage to the
motor may occur.
To clean or replace the motor
protection filter, remove the dust bag
or pull the bag forward. The motor
protection filter sits in grooves located
at the rear of this dust bag chamber.
Pull the plastic filter holder upward to
remove. To clean, separate the foam
filter from the plastic holder and
shake debris from the filter into a
garbage receptacle.
When clean, replace the foam filter
into the plastic holder and reinsert into
the vacuum by pushing downwards
into the grooves provided. To replace
the filter, dispose of old filter and
insert a new, clean filter into the
vacuum cleaner.
Exhaust Filter
The exhaust filter should be cleaned
after every use for maximum
vacuuming performance. To clean,
simply unclip the grill at the back
of the vacuum cleaner and shake
and tap the filter to remove any dust
accumulated. Then relocate the filter
and reattach the grill.
NOTE:
Dirty and clogged
filters may result in reduced
suction performance. It is
recommended that filters are
cleaned after every use and
replaced regularly to ensure
maximum efficiency from
your vacuum. If filters are left
uncleaned, it may result in
reduction of suction power.
