7
Using Your Essentials 500 Watt Blender
Before First Use
Before using your Kambrook Essentials
Blender for the first time, remove all
packaging material and promotional
labels. Ensure the appliance is
switched off at the power outlet and
power cord is unplugged.
Wash the lid, inner cap and blender
jug in warm soapy water with a soft
cloth. Rinse and dry thoroughly (refer
to care and cleaning instructions).
The motor base can be wiped with
a damp cloth. Dry thoroughly.
Assembling/Operating Your
Kambrook Blender
1.
Place the power cord through
the cord slot and place the motor
base on a flat, dry surface. Ensure
that the blender is switched off at
the power outlet and the power
plug is unplugged from the
power outlet.
2.
Place the blender jug onto the
motor base. Ensure that the
blender jug is securely positioned.
3.
Add food or liquid to the blender
jug. Place the lid on the blender,
and push down to seal. Insert the
inner cap into the hole of the
blender jug lid.
4.
Plug the power cord into a 230V
or 240V power outlet and switch
on at the power point.
5.
Turn the speed control dial
clockwise for the speeds
‘LOW’ and ‘HIGH’ setting and
anticlockwise for ‘PULSE’ setting.
The speed can be changed at
any time during the blending
process. Ideally, start blending on
‘LOW’ speed and then increase
to a ‘HIGH’ speed if necessary to
blend until desired consistency
is reached. For ingredients that
require a short burst of power, use
the pulse speed. This is ideal for
thick liquids or nuts.
6.
To stop the blending at any time,
turn the speed control dial to ‘OFF’.
7.
After use, ensure the blender
is switched off by turning the
speed control dial to the ‘OFF’
position, then switch off at the
power outlet and remove the
power cord. Allow the blender
to cool before storing.
NOTE:
During the blending
process, ingredients may
stick to the sides of the blender
jug. To push the food back
on the blades, turn the speed
control dial to ‘OFF’ and switch
the power off at the power
outlet and remove the power
cord. Remove the lid and
use a plastic spatula to
scrape down the sides of
the jug. Replace lid before
recommencing blending.
NOTE:
If the blades become
stuck, immediately select the
speed control dial to ‘OFF’
and switch the power off at the
power outlet and remove the
power cord. Remove the jug
from the blender base and
remove the lid. Use a plastic
spatula to dislodge the food
or liquid from the blades.
Replace lid before
recommencing blending.
