Boilie Cannon - User's Manual
15
preconfigured in factory based on average boilie physical properties and
should work with most of the boilies. However, if you notice that your
boilies are leaving the Boilie Cannon too low or too high, you can use this
simple procedure to adjust vertical ejection angle:
1.
Turn off device completely with power button.
2.
Locate vertical ejection angle adjustment potentiometer by looking
through boilie diameter adjustment opening while slowly rotating
disc by hand through boilie ejection opening, as illustrated on the
image below.
3.
Use supplied screwdriver to adjust vertical ejection angle. Turning
the screwdriver clockwise will increase vertical ejection angle, and
vice versa. Do the adjustments in small steps.
4.
Turn on your device and test your new adjustments. During the
testing of new adjustments it is possible that your changes were too
large and that boilies are being ejected inside the Boilie Cannon, not
leaving the ejection opening. Therefore, during the testing, never
use more than 30% of power. Once your settings are confirmed with
low power with couple of boilies, you can start using the full power.
Boilie insertion
opening
Boilie vertical
ejection angle
adjustment
opening
Summary of Contents for Boilie Cannon
Page 1: ...User s Manual January 2021...
Page 2: ......
