Instruction for connecting gas circuit
to LPG cylinder
Keep at hand suitable crossed screwdriver,
adjustable spanners, pliers and wrenches.
Before assembly, make sure all protection
packing material has been removed.
Flexible
gas hose(1763-1) and clamps (if necessary)
are supplied with this appliance and must
be used, in accordance with regulations.
The gas regulator has to be set according
to specific gas category (see on page 2) and
proper gas consumption (g/h) specification.
The LPG cylinder should be standard one.
Recommend to use 5 kg . Replacement must
be that specified in “Gas Requirements” section
of this Instruction Manual. Be careful: do not
kink flexible gas rubber pipe of gas circuit. If
pipe holder should not be provided, thread
of the gas inlet connection will be in line with
Standards ISO 7-1 or ISO 228-1, according
to National Rules in force of the country of
destination.
1.
Make sure appliance gas knob is turned
“OFF” (full disk) before assembling
(Fig 3).
Fig 3
2.
Put the LPG cylinder inside of the tank
bracket,and tight the screw
(see Fig 4)
Fig 4
