Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
Print only
what is inside the frame.
10
IKP 40625 - 141007
Assembly page 10/24
Fax +1 305 430 9692
445F. When the unit detects a temperature above this limit,
intermittent heating mode will be automatically engaged to avoid a
too high temperature increase and allow for a safe cooking.
ERROR CODE TABLE
Error
code
Cause
Suggested solution
E0, E2,
E5, E6 or
E7
Internal circuit error –
parts could be
overheating or have an
open or short circuit
Contact Kalorik’s Customer Service.
See the „Warranty section“ for
details.
E1
Cookware not detected
1.
Check if the cookware has a
magnetic bottom.
2.
Ensure the cookware is placed
within the circular placement
guide indicated on the glass
top
3.
Cookware was removed
during cooking – replace back
on cooktop.
E3
Voltage too high
Have your power supply checked
(it should be 110/120V AC); Unplug
the appliance, wait about 2 min.
and plug in the appliance again
E4
Voltage too low
Have your power supply checked
(it should be 110/120V AC); Unplug
the appliance, wait about 2 min.
and plug in the appliance again
E7
Overheat protection
1.
In “Power” mode: check that
the liquid has not completely
evaporated (Boil dry).
2.
If you are not heating liquids,
switch the unit off and then
back on; switch to
“Temperature” mode to
enable a correct temperature
regulation
3.
In “Temperature” mode: switch
the unit off, remove the
cookware and leave the
appliance cool down.