INSTALLATION INSTRUCTIONS
Tuxedo™ Console Table
1102264_2_B
Page 4 of 5
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
ASSeMBLe THe FRONT CONSOLe TABLe LeGS
3.
Towel Bar
Height Adjustment
Pads
Mounting
Bracket
Towel Bar
Orientation Hole
Dowel
Set the height adjustment pads on the front
legs to match the height of the top of the
mounting bracket, taking into account floor
height differences at the leg mounting loca-
tions.
With an assistant
, install the towel bar into
the front legs, making sure to align the dowel
with the towel bar orientation hole.
Install the front legs into their floor mounting
holes.
INSTALL THe CONSOLe TOP
4.
Threaded
Rods
Mounting
Bracket
Console
Top
Place the stone console top upside down to install the
lavatory.
NOTe: When installing the lavatory, use the clips provided
with the lavatory and the hardware provided with the console
top.
Install the lavatory according to the manufacturer’s
instructions.
With an assistant or two
, hold the front legs and gently
put the stone console top on the mounting bracket and
front legs. The threaded rods protruding from the top of
the legs must be inserted into the appropriate holes in
the bottom of the stone console top.
Check that the table top is level. Adjust the wall bracket
and front legs as needed.
If using the optional rear console table legs, proceed
to step 5.
Apply a small amount of caulk or silicone sealant where
the legs meet the stone console top.
Install the 16mm screws and fender washers through the
wall bracket into the threaded holes in the underside of
the stone console top.
