INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1158696_2_A
5 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
5. COMPLETE THE INSTALLATION
If desired, apply a bead of caulk or silicone sealant where the marble console top meets the wall.
Install the p-trap according to the manufacturer’s instructions.
Connect the water supply and check all connections for leaks. Repair as needed.
6. REMOVE/ADJUST THE DOORS AND HINGES
Side of Vanity
Top of Door
Hinge Cup
Hinge Base
Slot
Bracket
Latch
Adjustments
Side
Depth
Height
Door
Removal:
Hold the door in place with one hand while releasing the latch from the bracket at each hinge assembly
location on the door. The door will detach from the hinges. Set the door aside.
Replacement/Reinstallation:
Line up the latch pin on the hinge cup with the groove on the hinge base, then snap into place.
Open and close the door to confirm smooth operation. Adjust the screws on the hinge assembly as needed.
Adjustment:
NOTE:
Refer to the hinge assembly illustration above to select the screw that corresponds to the adjustment
needed.
Height - to move the door up or down
- Turn the screw either way on the bottom and top hinge assembly
until proper adjustment is achieved.
Side - to move the door to the left or to the right
- Turn the screw either way on the bottom and top
hinge assembly until proper adjustment is achieved.
Depth - to move the door in or out
- Loosen the screw on the bottom and top hinge assembly, hold the
door in the desired position, then retighten the screws.
