INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1158696_2_A
2 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual
before you install your KALLISTA product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
BEFORE YOU BEGIN
These instructions are for installing the wooden vanity cabinet (P73066 or P73067) and pre-cut marble
vanity top (P73063).
Observe all local plumbing and building codes.
Prior to installation, unpack the new vanity and marble top and inspect them for damage. Return the vanity
and marble top to their protective cartons until you are ready to install them.
Refer to the vanity specification sheet for P-trap and supply location recommendations. Verify your supply
valves and P-trap will not interfere with the shelf and drawer. Install the water supply and drain lines. The
water supply nipples must extend 3″ (7.6 cm) beyond the finished wall material.
These instructions are for installing the wooden vanity cabinet to wood frame construction. For other
installations, supply suitable bracing and fastening devices of sufficient size and strength.
Provide 2x6 backing material in the finished wall. The height from the top of the 2x6 backing material to the
floor must be 36-1/4″ (92.1 cm).
This installation is recommended to be done with a minimum of two people.
All dimensions given assume that the floor and walls are square, plumb, and level. Make appropriate
adjustments for other conditions.
Remove any moldings that may inhibit the vanity from being flush against the finished wall.
Make sure the path of the door will not be obstructed as it swings open.
KALLISTA reserves the right to make revisions in the design of products without notice, as specified in the
Price Book.
TOOLS AND MATERIALS
Pencil
Tape
Measure
Level
Drill
Hex
Wrench
Clear 100% Silicone
Sealant or Caulk
File
Hammer
Safety Glasses
Plus
● Conventional woodworking
tools and materials, as
appropriate
● Hole Saw
● Wood Screws
● Screwdriver
