INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1158696_2_A
3 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
1. WALL PREPARATION
36-1/4”
(92.1 cm)
2x6 Backing Material
Measure and mark 36-1/4″ (92.1 cm) up from the floor. This will
be the height from the top of the 2x6 backing material to the
floor.
Secure the 2x6 backing material to the studs with framing nails.
Install the water supply and drain lines. The water supply
nipples must extend at least 3″ (7.6 cm) beyond the finished
wall material.
Complete the finished wall. Make sure that the finished wall is
straight and plumb, and that the floor is flat and perpendicular
to the finished wall.
IMPORTANT!
Do not install any moldings that may inhibit the vanity
from being plumb against the finished wall.
2. TEST FIT THE VANITY AND MARBLE
Mark supply and drain locations.
Wooden Vanity Cabinet
Levelers
Position the wooden vanity cabinet against the
finished wall.
Verify the wooden vanity cabinet is level front
to back and side to side. If necessary, adjust
the levelers on the bottom of the wooden
vanity cabinet.
Mark the supply and drain locations on the
inside of the wooden vanity cabinet back wall.
Move the wooden vanity cabinet away from
the wall.
Cut the marked supply and drain locations
from inside of the wooden vanity cabinet using
a hole saw.
Position the wooden vanity cabinet against the
wall, aligning the supply and drain locations
with the cut holes on the wooden vanity
cabinet back wall.
