Thank You For Choosing Kallista
We appreciate your commitment to Kallista quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kallista.
Tools and Materials
Before You Begin
CAUTION: Risk of personal injury or product damage.
Handle
with care. The product can break, chip, cause injury, or product
damage if handled carelessly. Get assistance lifting the product
into place.
CAUTION: Risk of hazardous gases.
If the new toilet is not
installed immediately, temporarily place a large damp rag in the
closet flange to limit exposure to sewer gases.
Observe all local plumbing and building codes.
Carefully inspect the new toilet for damage.
This product consists of a two-piece toilet with standard lift knob
and toilet seat.
If the existing toilet does not have a supply shut-off valve below
the tank, install one before installing the new toilet.
If the floor or closet flange is not level, the toilet may not be level
after it is installed.
Provide adequate clearance for the toilet lift rod. When raised, the
top of the lift rod reaches 34-1/8
″
(86.7 cm) above the floor.
10" Adjustable
Wrench
Supply
Shut-Off
Valve
Tape
Measure
Pipe Wrench
Tubing Cutter
Safety
Glasses
Sponge
Level
Plus:
Wax Seal
• 5/16" T-Bolts w/ Nuts and Washers
• Putty Knife
• Metal File
• 1/2" Nut Driver/Socket
• Hacksaw
• Screwdriver
1008379-2-A
2
Kallista
