6. Complete the Installation
NOTE:
Your toilet trip lever location may vary from the illustration.
The installation instructions still apply.
Connect the Supply
Connect the supply shut-off valve to the toilet supply shank.
Open the supply shut-off valve slowly to check for leaks. If the
connections have been properly assembled, a slight tightening of
the nuts should stop leakage.
Adjust the Water Level
Slightly lift the cover from the toilet tank.
Squeeze and slide the clip on the float rod to adjust the water
level. Slide the clip up to raise the water level. Slid the clip down
to lower the water level.
Test flush the toilet several times, while checking all connections
for leaks, to ensure proper operation.
For All Installations
Carefully set the cover onto the tank.
Flush the toilet several times and check all connections for leaks.
Periodically check for leaks for several days following the
installation.
Ferrule
Supply Shank
Tubing
Compression
Washer
Compression
Nut
Supply
Shut-Off
Valve
Supply Shut-Off Valve
Connection
Coupling
Nut
Fill Valve
Nut
Seal
Washer
C-Clip
Waterline
Adjusting the Water Level
1008379-2-A
10
Kallista
