Ensure the rubber gasket is on the inside of
the cistern tank. Holding outlet valve in place,
thread large plastic locknut onto threads of
outlet valve. Hand-tighten locknut and use large
adjustable pliers to go 1/2 turn beyond hand
tight.
DO NOT OVERTIGHTEN.
Once the old fitting is removed and the tank
has been cleaned, insert the Fluidmaster outlet
valve into position.
Note: Position cable
opposite to inlet fill valve and ensure
cable does not interfere with any
moving parts within toilet cistern.
After turning the water off, remove the old
fitting by removing the locking nut under the
toilet tank.
1
4
IMPORTANT: Prior to installation, turn the water off at the wall, flush toilet cistern and mop up the residual water to avoid spillage before
removing the old outlet valve. After removing the old outlet valve, please clean the cistern tank of all dirt and grime, and ensure no debris
is left in the tank.
Select from the following 5 applications the correct mounting method for your toilet cistern and follow the instructions
Button Part
Descriptions
FLUIDMASTER
®
580AU CABLE DUAL FLUSH VALVE
INSTALLATION INSTRUCTIONS FOR TOILET CISTERN
PART# 25-1329 Grev 4 09/17
Wall Mount Cisterns:
Connect the existing
flush pipe to the base of the outlet valve and
hand tighten the nut (Do not overtighten).
Ensure the flush pipe nut washer is in good
condition.
Button
Big Nut
REMOVE & DISCARD
REMOVE & DISCARD
REMOVE & DISCARD
Button Collar
Button Collar
Outer Flange
Outer Flange
Outer Flange
Button
Outer Flange
Button Collar
Big Nut
Small Nut
Small Nut
Small Nut
Button
Button
Button
Button Collar
Button Collar
Small Nut
Small Nut
Big Nut
Big Nut
REMOVE & DISCARD
Outer Flange
Big Nut
Button Lock
Small Nut
Button Collar
REMOVE & DISCARD
Outer Flange
Big Nut
Application A:
Top Push Button 38mm
Application B:
Top Push Button 48mm
Application C:
Side Push Button
Application D:
Front Push Button
Application E:
16-25mm Hole
4B. Ensure the cable runs smoothly & does not interfere with the workings of the valve.
4C. Slide button lock in; secure button box to button & release to lock.
Button Lock
Button Box
IMPORTANT: DO NOT USE PLUMBER´S PUTTY TO SEAL THIS CABLE DUAL FLUSH VALVE
WM-022481
2
6
The over flow tube height can be adjusted up
and down. Turn the over flow tube to the right
to unlock. Adjust height to suit and turn the
over flow tube to the left to lock. Ensure top of
overflow is 25mm below the CL (Critical Level)
line on the inlet valve. This is to ensure the
correct air gap.
3
7A
A.
To adjust
FULL VOLUME
, first slide small
tab to the unlock position. Push larger tab
upwards for less water and downwards for
more water.
B.
To adjust
PARTIAL VOLUME
, push tab
inwards while sliding tab upwards for less
water and downwards for more water.
PARTIAL
FLUSH
B
FULL
FLUSH
A
LESS
MORE
1
6
LESS
MORE
12
1
5
A
B
File Name:
25-1329_Grev4_580AU_Instructions_092817
Printing & Finishing: 4/C Offset
Colors:
C
M
Y
K
DIE
PMS Colors:
