INSTALLATION INSTRUCTIONS
Two-Handle Wall-Mount Bath Valve
1085232-2-
A
© 2013 KALLISTA
4 of 4
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
2. INSTALL The YOke
Backer Board
(Not Supplied)
Temporary Nipple
Bath Ell
1/2" Supply Pipe
Nut
1/2" Threaded
Pipe Union
4" (102 mm)
Typical
4" (102 mm)
Typical
Yoke
Cold
Hot
NOTe:
Typical dimensions are shown on the roughing-in diagram.
NOTe:
Refer to the trim installations for specific requirements.
NOTe:
Refer to the handle installation instructions for possible roughing-in depth requirements.
NOTe:
The faucet fitting is factory assembled for hot and cold water.
Unless otherwise instructed, rough-in the supply yoke 3" (76 mm) minimum to 4" (102 mm) maximum from
the center of the supply inlets to the outside of the finished wall.
Install 1/2" hot and cold supply pipes.
Slide the nuts over the supply pipes and then thread the 1/2" threaded pipe unions onto the ends of the
supply pipes.
Thread the nuts onto the yoke.
Install the pipes and adapters between the yoke and bath ell.
Secure the yoke, supply pipes, and bath ell to the backer boards.
Install a temporary 1/2" nipple into the bath ell.