INSTALLATION INSTRUCTIONS
Pressure Balance Trim
1491056-2-
A
5 of 14
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
3. INSTALL THE FACEPLATE AND HANDLE
Discard plaster guard with dome.
Valve Stem
Diverter Actuator
Valve Seal
Diverter Seal
Screw
Faceplate
Setscrew
Collar
Handle
Tiled Wall Installations Only
, apply silicone sealant.
Fit diverter seal over diverter actuator (if applicable) and valve seal over valve stem, as shown. Align the
notches in the valve seal with the threaded holes in the valve.
Install the faceplate onto the valve. Secure with two screws. Do not overtighten.
Rotate the valve stem fully counter clockwise.
Slide the collar onto the valve.
Place the handle assembly over the valve stem so that the setscrew is aligned with the large groove on the
valve stem. If using the lever handle, make sure that the handle points straight down. Tighten the setscrew.
If supplied, remove the aerator.
Run the water to flush debris, then reinstall the aerator.
