INSTALLATION INSTRUCTIONS
One™ Wall-mount Bridge Kitchen Faucet
1102266_2_A
3 of 5
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
PRePARe The SITe
1.
Escutcheon
2x4
Riser Tube
Pipe
Nipple
Apply
sealant
tape.
8"
(20.3 cm)
Rough-in the Plumbing
IMPORTANT!
For exterior wall installations: Ensure proper wall insulation to prevent frozen pipes.
Attach a 2x4 between two studs according to the illustration.
Position the riser tubes 8″ (20.3 cm) apart, then level, and secure the elbows and risers to the 2x4.
Temporarily secure a pipe nipple to each elbow with sealant tape.
Confirm the pipe nipples are perpendicular to the front edge of the vertical 2x4s.
Confirm the Rough-in Plumbing
Hand tighten an escutcheon onto each pipe nipple.
Slide the faucet assembly onto the escutcheons.
Ensure the escutcheons are aligned and level with one another.
Further tighten the escutcheons, if necessary.
Verify the faucet assembly is properly aligned and level. If necessary, make adjustments by repositioning
the elbows, or escutcheons.
Remove the faucet assembly and escutcheons.
Site Checkout
Flush the water lines.
Cap the pipe nipples and check for leaks at the elbows.
Complete the finished wall.
