Adjusting the angle lever – fine adjustment
➢
Set the Revo twistgrip to (2).
Turn the cable adjustment screw so that the red line on the rod is aligned
to the end of the hub axle.
The red line on the rod and the end of the hub axle must be aligned
to one another.
If the red line is not visible, the yellow part of the intermediate piece
must be adjusted between the two yellow lines of the window.
20
If the clip nut loosens itself from the brake arm or the clip screw or brake
arm clip are damaged, the brake arm can rotate on the chainstay. This can cause
the handlebar to move suddenly or the wheel to lock, which can lead to a fall with
serious injuries.
Mounting the Shimano
3-speed hub gear shifter unit
➢
Insert the rod in the hub axle.
➢
Push the angle lever into the hub axle
and align the inner lever serration to
the flange nut; push the angle lever
until it is contacting the hub axle.
In this condition, tighten the hub
axle fixing screw.
SET
SET
5 mm allen key
or 10 mm spanner
Fixing screw
Tightening torque:
3 – 5 Nm
Edge of
the window
SET
SET
Flange nut
The edge of the window
must be aligned to
the end of the hub axle.
End of the hub axle
SET
SET
The two yellow lines
must be viewed directly
from above.
Note:
End of the hub axle
Red line
on the rod
Yellow line
Yellow line
Yellow part of the
intermediate piece
SET
SET
Rod
Cable adjustment screw
Set to
2
Rod
The end of the rod must protrude approx.
14 mm beyond the hub axle.
approx 14 mm
DCW BedienA_GB UNI.qxd 24.10.2007 12:50 Uhr Seite 20
