Kalfire Gi75/59F, Installation Instructions Manual

Page: 25 / 60

25
Fireplace on
Press and hold the "fireplace on/off" button until
the KalSense ring "fills up", then immediately
release the button. The fireplace goes through
the start-up cycle. During the start-up cycle, the
KalSense ring flashes orange.
The start-up cycle is complete when the KalSense
ring lights up white briefly and then goes out.
WARNING!
The entire start-up cycle takes several minutes
(the fire goes through a safety protocol, among
other things, during the start-up cycle).
Switching on the fire / start -up cycle
If the on/off button has been held for too long or
too short a time, the KalSense ring briefly lights
up red.
Restart the fireplace.
WARNING!
During the start-up cycle, you cannot operate the
various functions of the fireplace. However, you
can abort the start-up cycle with the on/off
button.
WARNING!
You should wait at least 3 minutes after aborting
the start-up cycle before restarting the fireplace.
If the fireplace interrupts the start-up cycle for
technical reasons or if the fireplace goes out after
completing the start-up cycle, this may have
several causes.
Switching off the fireplace
From run mode (the fireplace is on): press button
1 x (do not hold) to switch off the fireplace. The
KalSense ring lights up briefly.
C function
Moves to the last used comfort plus setting.
KalSense feedback: green
Manual operation
From the programmed modes (,
thermostat function and Moods) back to manual
control.
KalSense feedback: white
Thermostat
Moves to the last thermostat setting selected.
KalSense feedback: turquoise
Increase flame height
Increase flame height, positions 1 to 5. Position 1:
centre burner on low setting only, position 2: 3
burners on low setting, position 3, position 4,
position 5: 3 burners on high setting.
KalSense feedback: orange
Reduce flame height
Reduce flame height, position 5 to 1. position 5:
3 burners on high setting, position 4, position 3,
position 2: 3 burners on low setting, position 1:
only middle burner on low setting.
KalSense feedback: orange
Comfort
Comfort setting: gas and heat savings thanks to
modulating flame height.
osition 1: three burners modulate at the highest
setting.
Position 2 and 3, the average flame height of the
three modulating burners gets lower each time.
Position 4: only the middle burner burns,
modulating, at high setting.
Position 5: only the middle burner burns at the
lowest setting. The greatest savings take place at
this setting.
KalSense feedback: green