KALATEL Calibur DVMRe, User Manual, Page: 48 / 80

Calibur DVMRe - 48 - 0150-0138D
Main Menu
→
Alarms
→
Relay Configuration
Relay Configuration
Use this menu to configure each relay output as either:
• Normally Open
•
Normally Closed
Relay 01: N/OPEN
Relay 02: N/CLOSED
[CANCEL] [OK]
Main Menu
→
Alarms
→
Buzzer Setup
Buzzer Setup
Use this menu to configure the internal buzzer.
Global Buzzer: The Global Buzzer setting acts as a master On/Off
switch. Setting the Global Buzzer to OFF deactivates all buzzer
activity.
Live Alarm Buzzer: Activates while receiving alarm input.
Videoloss Buzzer: Activates when video loss is detected.
Global Buzzer : ON
Live Alarm Buzzer: ON
Videoloss Buzzer : ON
Playback Buzzer : ON
[CANCEL] [OK]
Disabling the Videoloss buzzer disables all videoloss buzzer activity. Videoloss buzzers may be
disabled on a per camera basis in the
Alarms → → → → Videoloss Action menu.
Playback Buzzer: Activates during playback of recorded alarms.
Main Menu
→
Alarms
→
Videoloss Action
Videoloss Action
Use this menu to configure how the unit responds to videoloss.
Camera: Select the camera you wish to configure.
Relay 1: If enabled, the unit will activate Relay 1 when videoloss is
detected.
Relay 2: If enabled, the unit will activate Relay 2 when videoloss is
detected.
Camera : 01
Relay 1: DISABLE
Relay 2: ENABLE
Buzzer : ENABLE
[CANCEL] [OK]
Buzzer: Use this setting to disable the videoloss buzzer activation on a per camera basis. To disable
videoloss buzzer activation on all cameras go to the Main Menu
→
→ →
→
Alarms
→
→ →
→
Buzzer Setup menu,
described in the previous section.
Main Menu
→
Alarms
→
Pre Alarm Duration
Pre Alarm Duration
During recording, the unit stores up to 5 seconds of recorded
information in a buffer. This data can be automatically retrieved
when an alarm is activated. Select the amount of time just previous
to the activation of an alarm you wish to retrieve.
(Time in Seconds)
02
Main Menu
→
Alarms
→
Archive Alarms
Archive Alarm
Selecting Enable from this menu will cause the unit to activate Relay
2 if a malfunction occurs while archiving.
Relay 2 : Enable
[CANCEL] [OK]