0150-0163f
1-5
Calibur DSR
Power Connector
Power Supply Input
Power Supply Output
Voltage:
120 to 240 Volt AC
Tolerance:
±10%
Frequency:
50 to 60 Hz
Voltage:
12 Volt DC
Power:
35 Watt
Connector:
2.1mm barrel, Center
Positive
SCSI Port
Connector:
50 Pin, High Density SCSI-2.
Gender (on unit):
Female
Compatible devices:
DAT, AIT, CD-R, CD-RW
Autoloader Support?:
Yes
SCSI ID:
0
The unit is equipped with a SCSI port for
connecting external archive devices. The unit only
supports a single SCSI device. The SCSI ID must
be set to 0.
The SCSI bus must be terminated, otherwise the
system will not operate properly.
Additional menu setup may be necessary to
configure archive device. See section 4.6
Main
Menu
→
Archive Setup.
RS-232 Serial Port
Use a Null Modem cable when connecting to a
PC. When connecting to a multiplexer, it may
be necessary to construct a cable using the pin-
out documentation of the MUX as a guide. See
the pin-out configuration for the DSR below.
Connector Type:
DB-9
Gender (on unit):
Male
Cable Required (Connected to PC):
Null Modem
Cable Required (Connected to Multiplexer):
Variable, depending on pin-out configuration of
MUX.
DB-9 Pin Configuration for Serial Port
Pin
Use
Pin
Use
Pin
Use
1
DCD
4
Not Connected
7
RTS
2
RX
5
Ground
8
CTS
3
TX
6
Not Connected
9
Not Connected
5
1
9
6
DB-9 on rear panel.
Summary of Contents for Calibur DSR-2000e
