NOTE: THESE SAFETY RULES ARE FOR YOUR BENEFIT TO HELP
PREVENT INJURY TO YOURSELF AND/OR YOUR CO-WORKERS.
REVIEW ALL SETUP AND OPERATING PROCEDURES, WHETHER
COVERED OR NOT, IN THIS MANUAL TO HELP INSURE SAFE
OPERATION OF THE MACHINE.
MACHINE SET UP
1. Remove machine from packaging.
2. Assemble stand by bolting through the bottom of stand with the M12x60
allen bolt.
3. Then secure gusset from the top with (2) M8X16 bolts.
4. Place machine on top of the bead roller stand and secure using (2)
M10x25 allen bolts.
5. Remove the shoulder bolt holding the aluminum handle to the bottom of the
bead depth adjuster.
6. Place the aluminum handle on top f the bead depth adjuster and secure
using the shoulder bolt.
7. Remove the (2) M10x25 allen bolts and washers from the ends of the
shafts.
8. Turn the bead depth adjuster counter-clockwise a few turns to allow room
for the rolls to slide onto the shafts.
9. Place the bead rolls on the shafts toward the machine. Either roll can be put
either shaft, but we usually recommend that the male type roll go on the
top.
10. Secure the rolls to the shafts with the bolts removed in step #7 and snug
them down.
11. Unwrap power cord and variable speed foot pedal.
12.Plug in the 110v volt power.
