13.Machine is now ready for use.
OPERATION
1. Step down on the foot pedal to determine if the rolls are turning in the
direction you are going to feed the metal from.
2. Release the foot pedal.
3. If the rolls are not turning in the proper direction, flip the forward / reverse
switch.
4. Now you are ready to set your bead depth. This step will require some
experimentation to get the proper depth so it is recommended that you use
a scrap piece of the same material you want to bead roll.
5. Do not start with the rolls completely closed as you may find that the rolls
are too close together and find it difficult to feed the material.
6. Lightly step down on the foot pedal and feed the metal in from the desired
side of the machine. The foot pedal controls the speed.
7. Turn the bead depth adjustment clockwise until you get the desired bead
depth. Now you are ready to bead roll your panel.
8. If you find that you need to change the direction of the rolls during a bead,
release the foot pedal before changing from forward to reverse.
Part list
Item
Description
Specification
Qty
1
Motor
0.9 kw
1
2
Key
5x16
1
3
Linker
AL-075-16H
1
4
Washer of linker
AL-075
1
5
Linker
AL-075-19H
1
6
gear
2
7
Spring roll pin
6X50
2
8
Set collar
26
2
