KAKA Industrial BS-126G, Assembly & Operating Instruction

Page: 9 / 20

Code START-STOP MICROSWITCH: situated inside the handle located at the
end of the control lever and has safety release action.
Code ELECTRIC PUMP
Code CUTTING ANGLE DEVICE: to check that cutting inclination is as required
Code LOCKING VICE
Code BAR STOP
Code CONTROL LEVER WITH HANDLE
8.2 TOOLS SUPPLIED
1 Allen wrench size 3
1 Allen wrench size 5
1 Allen wrench size 6
1 Allen wrench size 8
1 Allen wrench size 10
8.3 OPERATION
CHECKES TO CARRY OUT BEFORE EACH CUT
A Tension the band by rotating the hand wheel to the end of stroke (mechanic stop)
Remember at the end of the operation to loosen the hand wheel to avoid the
slackening of the band.
B Check that the hand indicates the required cutting angle (vice scale).
C Make sure that the bow and the vice are locked by means of the lever.
D With the motor off, lower the bow and check that at the end of stroke, the band does
not touch the counter-vice. If the band does touch, adjust the screw located on the
bow.
E Make sure that the piece to be cut is properly secured in the vice.
F Make sure that the cooling liquid is circulating in the machine.
IT IS STRICTLY FORBIDDEN TO USE THE MACHINE WITHOUT CUTTING FLUID
G When starting the motor, make sure that the band rotates in the direction of the arrow
shown in DRAW.
H To obtain maximum cutting accuracy
，
the unit must be located the nearest possible
to the work piece. Clamp the work piece with the vice. Release the blade guide arm
with clamping lever. And move it near the vice jaw so that it doesn’t touch it during the