KAKA Industrial BS-126G, Assembly & Operating Instruction

Page: 10 / 20

cutting operation, then secure it again. When carrying out this operation, make sure
that the blade guide guard does not come out of the bow guard leaving a part of the
blade exposed.
CUTTING OPERATION
A Before cutting, check that the inclination is the one required. In order to correct or
change the inclination, place the bench lever in position and after correction,
move it back to position.
B Clamp the material to be cut with the hand wheel 125 after having positioned the
clamp near the piece to be cut by lowering the lever 136 from position A to
position B allowing a fast displacement (DRAW.4 ENCL.3) with selector 151 in M
position. Turn the main switch 161 to the position required, take hold of the handle
95 located at the end of head lever and press the button. The blade will now start
turning, position the blade carefully on the piece to be cut. Then increase the
pressure in order to accelerate the cutting operation without using excessive
force.
C With selector 151 in CSO position
。
Turn the main switch 161 to the position
required. After having started the unit by pressing the START push button 150, the
blade starts to rotate. The down stroke of the bow can be adjusted by means of
the appropriate regulator. Position the blade carefully on the piece to be cut. Then
increase the pressure with the regulator in order to accelerate the cutting
operation without using excessive force.
D To make a series of cuts, position the bar stop in correspondence of the size
required. Fix it into position by using the hand wheel 121 (DRAW.6 ENCL.4).
E To replace the band, carry out the same operations used to assemble the band
(chapter 7c).
F For the choice of blade see table ENCL.1.
We strongly discourage the use of blades with ruined or insufficiently sharp
cutting edges
8.4 SPECIAL SAFETY CHECKS
A. Before using the machine, check carefully that the safety devices are in good working
order,, that the mobile parts are not blocked, that no parts are damaged and that all