3
1. ACCIDENT PREVENTION AND SAFETY INSTRUCTION
This machine has been designed to comply with national and community
accident-prevention regulations, improper use and / or tampering with the safety
devices will relieve the manufacturer of all responsibility.
1.1Advice for the operator
A. Check that the voltage indicated on the machine motor is the same as the line
voltage.
B. Check the efficiency of your electric supply and grounding system; connect the
power cable of machine to the socket and the ground lead (yellow-green) to the
grounding system.
C. When the saw frame is in suspended mode (or raised), the blade must not move.
D. Only the blade section used for cutting must be kept unprotected. To remove
guards operate on the adjustable head.
E. It is forbidden to use the machine without its shields.
F. Always disconnect the machine from the power socket before blade change or
carrying out any maintenance job, even in the case of abnormal machine operation.
G. Always wear suitable eye protection.
H. Never put your hands or arms into the cutting area while the machine is operating.
I. Do not shift the machine while it is cutting.
J. Do not wear loose clothing like: shirts with sleeves that are too long, gloves that are
too big, bracelets, chains or any other objects that could get caught in the machine
during operation. Tie back long hair.
K. Keep the area free of equipment, tools, or any other objects.
L. Perform only one operation at a time. Never have several objects in your hands at
the same time.
M. Keep your hands as clean as possible.
N. All internal operations, maintenance or repairs, must be performed in a well-lit area
or where is sufficient light from extra sources so as to avoid the risk of even slight
accidents.
1.2 The electric equipments according to European Standard “2006/42/EC”
which some integrating modifications.
A. The electric equipment ensures protection against electric shock as a result of
direct contact.
B. The active parts of this equipment are housed in a box to which access is limited by
screws that can only be removed with special tools; the parts are fed with
alternating current as low voltage (24V). The equipment is protected against
splashes of water and dust.
C. Protection of the system against short circuits is ensured by means of rapid fuses
and grounding; in the event of a motor overload, protection is provided by a thermal
probe.
D. In the event of a power cut, the specific start-up button must be reset.
E. The machine has been tested in conformity with European Standard.
