Pedal lock use and function:
(a)
Pedal lock is in “open” position
you are able to move pedal adapter
part and adjust the distance of the
footrest. (like in picture [a1] & [a2]
(b)
Pedal lock is in “locked” position.
While pedal lock is closed you are
not able to adjust the footrest which gives more security on paddling.
Assembling the footrest:
(a)
Slide the pedal onto the rail. Consider the end with oval shaped hole as the front end.
(b)
Place the foam washers on the fastening holes at the both ends of the rail.
(c)
Slide the rail end parts onto the both ends of the rail.
(d)
Fasten the rail itself by screwing it through the kayak hull from the outside. Screws don’t
attach the rail itself, but they fasten the rail end parts which will tighten the whole system
properly against the kayak hull.
Installing and using the steering rope:
The steering ropes are automatically adjusted in the KS-steering
system Pro, so basically you don’t have to adjust them separately
when moving the pedals. But in some cases you may want to do
some fine adjustment e.g. when installing the system. Kajak-Sport
has designed a small piece for that. With this piece you can
adjust the steering ropes simply and easily from few mm up to 30
cm.
1.
Coil the steering rope around the fine
adjustment piece.
2.
Thread the steering rope through the wooden
footplate.
3.
Thread the rope also through the innermost
hole of the plastic pedal.
4.
Further thread the rope through the bulkhead of
the rail end piece. Then tie a knot and press it
inside the rear block to hide it.
