kaivac
cleaning
systems
TM
kaivac
cleaning
systems
TM
1-800-287-1136
Customer/Technical Support
P a g e ǀ
2 0
3.3 s
pRay
-
and
-v
aC
o
peRation
3.0 Operation
The OmniFlex Spray-and-Vac system combines the 500 psi OmniFlex Pump System with the Wet Vacuum
and the Trolley-Bucket for extreme soil removal. It empowers workers to clean hygienically without touching
contaminated surfaces.
WARNING: DO NOT PUT
CHEMICAL IN TROLLEY-
BUCKET RESERVOIR WHEN
USING PUMP! DOING SO
WILL CAUSE PRODUCT
DAMAGE.
Tip
Receptacle
Cap
Draw Tube
To prepare the cleaning chemical, make sure the
Draw Tube is inserted into the Chemical Jug. In-
sert the Metering Tip as shown (see Metering Tip
Selection Chart on the Metering Tip Bag). Then
screw the Chemical Cap onto the Chemical Jug
and make sure the clear Chemical Line is con-
nected to the Chemical Cap.
To prime the pump:
Turn Spray Line Valve OFF,
turn ON the Pump Switch, then turn the Spray Line
Valve ON, and squeeze the Spray Gun trigger. If you
have issues with priming, call Technical Support.
Operate the Spray Gun as shown. Chemicals applied
in the Low Pressure setting only. Chemicals must be
cleared from the Spray Line prior to High Pressure
rinsing. To do this, turn OFF the Chemical Valve,
then spray in Low Pressure settings for 15 seconds.
Review Control Panel. Make sure Pump Switch and
Chemical Valve are in OFF position prior to plugging
in. If using with OmniFlex Vacuum Motor, plug in the
Vacuum Cord into control panel Receptacle.
Plug in and press the Black Test button on the GFCI
(Ground Fault Circuit Interrupter), then Red Light
should turn off. Then press the Red Reset button
and Red Light should come on.
Hour Meter
Fan Spray
Low
Pressure
High
Pressure
Pinpoint Spray
Pump Switch
Chemical Valve
Summary of Contents for OmniFlex TROLLEY BUCKET
Page 2: ...kaivac cleaning systems TM...
Page 32: ......