12
EN
1
2
3
ADJUSTMENT TO DIFFERENT GAS TYPES
The cookers are supplied with gas burners which the
manufacturer has adjusted to natural gas used in
your country. The type of gas is specified on the data
plate as well as in the warranty of quality. The data
plate is to find on the base or on the back of the
ɫ
ooker.
To adjust gas burners, remove knobs of the gas
burners.
To adjust the gas burners of the oven, withdraw the
bottom of the oven cavity.
To adjust the cooker to another type of gas:
x
replace a nozzle (see table 1),
x
adjust the lowerer pressure of the valves
x
adjust air supply to the gas burners of the oven.
1
– To replace the nozzle: screw out the nozzle (use
screw tip N° 7) and replace it with another one in
compliance with the available type of gas (see the
table 1).
2
– To adjust the burners: Switch on gas and select
“Sparing flame”. For adjustment, use a 2,5 mm-screw
tip.
3
– To replace the nozzle in the oven: See table 1 “a”
to adjust air supply correctly.
Table 1
Type of
gas
Burner: type / diameter
«
ɚ
»
Small Normal
Big
Oven
Natural gas
0,75 1,09 1,24 1,3
3
Liquid gas
0,52 0,67 0,84
0,84 10
Gas
supply
Adjusting from liquid
gas to natural gas
Adjusting from natural
gas to liquid gas
Full
flame
Nozzle burner 1
Replace in compliance
with Table 1
Nozzle burners 1
Replace in compliance
with Table 1
Saving
flame
Regulating
needle 2
Screw out slightly and
adjust the flame size
Adjusting needle 2
Screw in against the
stop and check up gas
supply
Attention!
(A hint for the serviceman) The
adjustment of the cooker to another gas type
should be registered at the connection
place.
Issue and attach a label with the gas type
which the cooker has been adjusted to.
