Easidew Transmitter User’s Manual
2
Issue 9.1 December 2012
INSTALLATION
2
INSTALLATION
2.1
Unpacking the Instrument
On delivery, please check that all the following standard components are in the packing
box:
•
Easidew Transmitter
•
Bonded Seal
•
Certificate of Calibration
•
Connector (for sensor/cable)
Unpack the dew-point transmitter box as follows:
8
7
6
5
3
4
2
1
Figure 1
Transmitter Unpacking Method
1.
Remove the cap (1) from the packing tube (8).
2.
Remove the foam block (3) containing the connector (2).
3.
Pull out the transmitter (5) from the tube, complete with the two foam
covers (6) and (7) and the red protective cap (4).
4.
Remove the foam covers from the transmitter but leave the blue plastic
protective cover (5) and the red cap (4) in place until ready for installation.
NOTE: The transmitter sensing element is protected while in transit by a blue
cover containing a small desiccant capsule. The connection pins are protected
by a red plastic cap. These plastic items must be removed for the operation
of the transmitter.
NOTE: Keep the connector (2) in a safe place until the transmitter is ready
for wiring.
Summary of Contents for Easidew
Page 20: ...http www kahn com...
